![background image](http://html1.mh-extra.com/html/desa/flame-max-vml27nr/flame-max-vml27nr_operation-and-installation-manual_2485877013.webp)
www.desatech.com
111115-01F
13
inStALLAtion
Continued
O
F
F
P
ILO
T
O
N
H
I
L
O
O
F
F
P
ILO
T
O
N
H
I
L
O
Fitting
Flexible Gas
Hose
(if allowed by
local codes)
O
F
F
P
ILO
T
O
N
H
I
L
O
O
F
F
P
ILO
T
O
N
H
I
L
O
Figure 11 - Attaching Flexible Gas Hose
to Heater
Figure 12 - Attaching Base Assembly to
Fireplace Floor
Masonry Screw
Mounting
Flange
INSTALLING HEATER BASE
ASSEMBLY
CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
WARNING: You must secure
this heater to fireplace floor. If
not, heater will move when you
adjust controls. Moving heater
may cause a gas leak.
WARNING: If installing in a
sunken fireplace, special care
is needed. You must raise the
fireplace floor to allow access
to heater control panel. This
will insure adequate air flow
and guard against sooting and
controls being damaged. Raise
fireplace floor with noncombus
-
tible material. Make sure material
is secure.
CAUTION: Do not pick up
heater base assembly by the
burner. This could damage
heater. Only handle base as
-
sembly by grates.
IMPORTANT:
Make sure the heater burner is
level. If heater is not level, heater will not work
properly.
Installation Items Needed
• hardware package (provided with heater)
• approved flexible gas hose (not provided) (if
allowed by local codes)
• sealant (resistant to propane/LP gas, not pro
-
vided)
• electric drill with 3/16" drill bit (metal or ma
-
sonry as applicable)
• flathead screwdriver
1. Apply pipe joint sealant lightly to male
threads of the fitting to be threaded into gas
control. Connect approved flexible gas hose
to gas control fitting in heater (see Figure 11).
IMPORTANT:
Hold gas fitting with wrench
when connecting flexible gas hose.
2. Locate two masonry screws in hardware
package.
3. Place heater base in fireplace.
4. Place logs in their proper position on heater
base. See
Installing Logs
, page 17.
5. Center heater base and logs front-to-back and
side-to-side in fireplace.
6. Carefully remove logs without moving heater
base.
7. Mark screw locations through one hole on
each side of the mounting bracket (see Figure
12). If installing in a brick-bottom fireplace,
mark screw locations in mortar joint of
bricks.
8. Remove heater base from fireplace. If install
-
ing optional control accessories, do so at this
time. Follow all directions provided with
accessory. See
Installing Optional Remote
Control Accessories
, page 14.
9. Drill holes at marked locations using 3/16"
drill bit.
10. Attach base assembly to fireplace floor using
two masonry screws (in hardware package).