![background image](http://html1.mh-extra.com/html/desa/comfort-glow-s39nt/comfort-glow-s39nt_owners-operation-and-installation-manual_2486501009.webp)
9
107434
OWNER’S MANUAL
For more information, visit www.desatech.com
INSTALLATION
Continued
WARNING: Never use an open
flame to check for a leak. Apply a
noncorrosive leak detection fluid
to all joints. Bubbles forming show
a leak. Correct all leaks at once.
WARNING: Test all gas pip-
ing and connections for leaks
after installing or servicing. Cor-
rect all leaks at once.
CHECKING GAS
CONNECTIONS
Pressure Testing Gas Supply
Piping System
Test Pressures In Excess Of 1/2 PSIG
(3.5 kPa)
1.
Disconnect appliance with its appliance
main gas valve (control valve) and equip-
ment shutoff valve from gas supply pip-
ing system. Pressures in excess of 1/2
psig will damage heater regulator.
2.
Cap off open end of gas pipe where
equipment shutoff valve was connected.
3.
Pressurize supply piping system by ei-
ther using compressed air or opening
main gas valve located on or near gas
meter.
4.
Check all joints of gas supply piping
system. Apply a noncorrosive leak de-
tection fluid to gas joints. Bubbles
forming show a leak.
5.
Correct all leaks at once.
6.
Reconnect heater and equipment
shutoff valve to gas supply. Check re-
connected fittings for leaks.
Test Pressures Equal To or Less Than
1/2 PSIG (3.5 kPa)
1.
Close equipment shutoff valve (see Fig-
ure 7).
2.
Pressurize supply piping system by ei-
ther using compressed air or opening
main gas valve located on or near gas
meter.
3.
Check all joints from gas meter to
equipment shutoff valve (see Figure 8).
Apply a noncorrosive leak detection
fluid to gas joints. Bubbles forming
show a leak.
4.
Correct all leaks at once.
ON
POSIT
O
POS
Figure 7- Equipment Shutoff Valve
Closed
Equipment
Shutoff
Valve
Open
Figure 8 - Checking Gas Joints
Pressure Testing Heater Gas
Connections
1.
Open equipment shutoff valve (see Fig-
ure 7).
2.
Open main gas valve located on or near
gas meter.
3.
Make sure control knob of heater is in
the OFF position.
4.
Check all joints from equipment shutoff
valve to control valve (see Figure 8).
Apply a noncorrosive leak detection
fluid to gas joints. Bubbles forming
show a leak.
5.
Correct all leaks at once.
6.
Light heater (see Operating Heater,
pages 13 and 14). Check all other in-
ternal joints for leaks.
7.
Turn off heater (see To Turn Off Gas to
Appliance, page 14).
Control Valve Location
Gas Meter
Equipment Shutoff Valve
Continued