www.desatech.com
119624-01A
8
OPERATING
INSTRUCTIONS
Continued
CLEANING AND
MAINTENANCE
WARNING: Always discon-
nect power and allow the heater
to cool before performing any
cleaning, maintenance or reloca-
tion of this heater. Turn controls
to OFF and remove plug from
outlet or turn off circuit breaker
to heater.
Turn off heater and circuit breaker to heater before
performing any cleaning and/or maintenance. Al-
low heater to cool completely.
CLEANING FIREBOx
COMpARTMENT
1. Remove screws that hold front panel in
place.
2. Carefully remove front panel.
3. Using the brush vacuum attachment, gently
clean compartment.
4. After cleaning compartment, replace front
panel. Reset circuit breaker.
BACK GLASS
1. The glass is cleaned in the factory during
assembly. During shipment, installation, han-
dling, etc. the glass surface may collect dust
particles. These can be removed by buffing
lightly with a clean dry cloth.
2. To remove fingerprints or other marks, the
glass can be cleaned with a damp cloth using
a good quality household glass cleaner. The
glass should be completely dried with a lint
free cloth or paper towel.
3. In the event of glass breakage, vacuum all
remaining glass pieces with a shop vac. DO
NOT VACUUM WHILE PIECES ARE HOT.
Replace glass only with replacement part
specifically for this heater. Never substitute
material. Only fully tempered soda lime safety
glass may be used on this heater.
6. The HEATER button activates the heater,
The heater is pre-set to the following
temperatures:
HI will shut off when room reaches approxi-
mately 86° F (30° C). The LED will be red.
MED will shut off when room reaches ap-
proximately 75° F (24° C). The LED will be
orange.
LO will shut off when room reaches ap-
proximately 64°F (18° C). The LED will be
green.
7. To adjust the light that shines on the logs
use the LAMP button. To increase or de-
crease, press the "-" or "+" buttons to cycle
through the four brightness settings.
8. To turn off the fireplace, press the ON/OFF
button once. When you restart the fireplace
with the remote control, all of the features
you had set will remain in effect.
NOTICE:
This remote control must remain
within 8 meters or 26 feet of the fireplace to
be effective.
FLAME
ON/OFF
+
-
+
-
HEATER
LAMP
Indicator
Light
Infrared
Ray Exit
Figure 6 - Remote Control For Electric
Fireplace
