![background image](http://html1.mh-extra.com/html/desa/bdv34n/bdv34n_owners-operation-and-installation-manual_2486256021.webp)
21
105453
OWNER’S MANUAL
REMOVING/REPLACING
GLASS DOOR
CAUTION: Do not operate this
fireplace with a broken glass door
panel or without the glass door
panel securely in place. For re-
placement part information see
Replacement Parts, page 30.
1.
Remove the upper louver panel by lift-
ing upward and out (see Figure 44).
2.
Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
Figure 45 - Removing/Replacing Glass Door
Figure 44 - Removing Top Louver Panel
Top Louver
Panel
Glass Door
Assembly
Screw
Lower Bracket for
Glass Door Assembly
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
FIREPLACE
INSTALLATION
Continued
Continued
Figure 40 - Disconnecting TH to TPTH
Wire
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
ACCESSORY - GHRC
Installing Remote Receiver
1.
Open bottom louver and locate the
switch bracket on the left.
2.
Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3.
Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt bat-
tery (not included) through the clip.
4.
Attach the terminal wires to the battery.
5.
Remove the wire that runs from TH to
TPTH from the valve (see Figure 40).
6.
Connect wires from reciever to TH and
TPTH on the valve (see Figure 41).
7.
Replace the switch bracket.
Figure 41 - Control Valve Terminals
t
Figure 42 - Attaching Battery to Receiver
9-Volt Battery
Receiver
Terminal
Wires
Battery Clip
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1.
Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt bat-
tery (not included). Place battery into
the battery housing.
3.
Replace battery cover onto remote con-
trol unit.
Figure 43 - Installing Battery in Hand-
Held Remote Control Unit
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
3.
Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 45).
4.
To replace glass door, follow the above
instructions in reverse.
To Wall Optional
Remote Accessory