17
105453
OWNER’S MANUAL
FIREPLACE
INSTALLATION
Continued
WARNING: Never touch the
blower wheel while in operation.
10. Peel off the backing paper and stick the
supplied wiring diagram decal on the
firebox bottom approximately 3" to the
right of the blower speed control
bracket (see Figure 33).
WARNING: Failure to position
the parts in accordance with sup-
plied diagrams or failure to use
only parts specifically approved
with this heater may result in dam-
age or personal injury.
11. Connect or reconnect gas supply to fire-
place per Connecting Fireplace to Gas
Supply on page 19 of this manual.
8.
Plug in blower power cord.
a. If your fireplace system is installed
as a freestanding unit with an ac-
cessory mantel, determine whether
the power cord will exit the left side
or the right side of the firebox. In-
stall one plastic bushing provided
into the 1
1
/
2
" hole in the outer cas-
ing through which the power cord
will exit. Install the second plastic
bushing provided into the floor sup-
port bracket if exiting through the
right side (see Figure 33). Route
power cord through (both) plastic
bushing(s) and plug the power cord
into a properly grounded 3-prong
wall receptacle near the firebox.
b. If your fireplace system installation
is recessed and/or pre-wired, a
qualified installer must make all elec-
trical connections for the outlet kit
included with the fireplace.
Figure 30 - Mounting Blower to Firebox
Top
Mounting
Tab
Exhaust Port
NOTICE: A qualified service per-
son must connect fireplace to
gas supply. Follow all local codes.
Screws
Blower
Lower Louver
Panel
Lower Rear
Wall of
Firebox
Wrapper
Figure 31 - Locating Thermal Switch Against Back of Firebox
Figure 32 - Attaching Speed Control to Firebox
Control
Knob
Locknut
Control Shaft
Plastic
Bushing
Figure 33 - Installing Plastic Bushing and Wiring Diagram Sticker
Wiring
Diagram
Continued
Speed
Control
9.
Check to make sure that the power cord
is completely clear of the blower wheel
and that there are no other foreign ob-
jects in blower wheel. Turn blower on
and check for operation. Turn blower
off by rotating knob fully counterclock-
wise before continuing.
Blower Speed
Control Bracket
Firebox Back
Firebox Flange
Firebox
Bottom
Thermal
Switch
Blower
Side View
Thermal Switch
