Se�ng up and opera�ng
PHOS rotator
29 / 56
En
gl
is
h
2.
Slide the new gobo holder into the mount and turn it
un�l the holding magnets have found their counter-
part.
(Note: For technical reasons, the gobo must be glued to the
gobo holder and can, therefore, only be changed as a unit.
For gobo orders, please contact our customer service
team).
5.2. Til�ng the projector head
1.
Loosen the four cylinder head screws of the housing
cover with the enclosed hexagon socket wrench.
2.
Disconnect the protec�ve conductor from the terminal
in the cover and remove it.
3.
Loosen the two cylinder head screws of the locking
device with the enclosed hexagonal spanner by no
more than one turn.
4.
Turn the projector head to the desired posi�on.
5.
Tighten the cylinder head screws of the locking device
again.
