En
gli
sh
Installa�on
26 / 56
Derksen Lich�echnik
2.
Loosen the cylinder head screw.
3.
Disassemble the lower cover to gain access to the con-
nec�on terminals.
4.3. Direct Wiring
1.
Loosen the four cylinder head screws of the housing
cover with the enclosed hexagon socket wrench.
4.
Release the cable screw connec�on on the back of the
housing.
5.
Release the connec�on terminals and remove the pre-
assembled power cord.
6.
Note that the cable gland is suitable for a maximum
cable diameter of 7 mm.
7.
Ensure the mains voltage matches the input voltage of
the projector as specified in the technical specifica-
�ons (220 – 240 V AC, 50 / 60 Hz) and your supply
cable is connected to a protec�ve conductor via the
corresponding contact on the terminal block.
8.
Tighten the screw connec�on.
ATTENTION! Poten�al Damage.
A ven�la�on element has been installed next to the
cable gland. This element must NOT be dismantled, ro-
tated or modified in any way. This is the only way to en-
sure its waterproof capability.
WARNING! Danger of electric shock!
An electric shock can cause serious injury
or death.
▶
Only allow a qualified electrician to
carry out electrical connec�ons.
