Notice SecurAccess PMR
39
number stored into its own memory. Chain dialing will operate if a number is stored in the second
memory of this button.
In this sample the key n°4 is used to dial with the keypad.
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf.
M1 Key n°4
3 5
Keep this memory empty
*9
M2 Key n°4
3 6
Number to store (* # = pause) (22 digits max)
*9
3.8. Chain dialing
This feature, when activated, will automatically keep on dialing a sequence of numbers stored into
the same memory/off-hook button if the other party does not answer or if busy line tone is detected, it
will only stop when another party answers.
Up to 5 different numbers can be stored in each memory and the dialing sequence can be repeated
up to 9 times. Time elapsed before the next call can be adjusted.
Programming this feature can be done locally or remotely.
Each button can store up to 5 numbers but, in order to activate the chain dialing, at least one number
must be stored to in order to repeat the dialing sequence (in case of just one number, this number
only would be repeated).
Example :
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf.
Number 1 Key n°1 (mandatory)
2 0
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
Number 2 for chain dialing on key n°1
2 1
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
Number 3 for chain dialing on key n°1
2 2
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
Number 4 for chain dialing on key n°1
2 3
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
Number 5 for chain dialing on key n°1
2 4
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
If a busy tone is detected, the unit will automatically dial the next number stored in the memory. In
case of no answer, time elapsed before dialing the following number stored can be adjusted as
shown below:
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf
Elapsed time before next call
0 8
0 : 10 seconds
1 : 20 seconds
2 : 35 seconds (factory setting)
3 : 1 minute
4 : 5 minutes
*9
In case of no busy tone and no answer, the dialing sequence can be repeated up to 9 times, choice
of the number of times can be made as shown:
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf.
Repeated dial
0 9
Enter 0 up to 9 (0 for no repeated dial),
note: factory setting = 0
*9
When the total numbers of calls has been completed, the SecurAccess will stop dialing and will hang
up.
