Notice SecurAccess PMR
38
Dial
0XNNNNNNNN
Calling the SecurAccess
2 “beep” tones
The SecurAccess answers and goes off-hook
Enter
*
Entering the programming mode
2 “beep” tones
Confirming the entry
Enter
0000
4 digits (Factory setting : 0000)
2 “beep” tones
Confirming the entry
Enter
06
Setting code access
2 “beep” tones
Confirming the entry
Enter
1
Setting choice (medium)
Enter
*9
Confirming stored setting
2 “beep” tones
Confirming the operation
3.4. Dialing mode (Tone/Pulse)
The SecurAccess offers the choice of Tone or Pulse dialing. Check with your operator or installer
before using the unit. Factory setting is Tone dialing.
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf
Dialing mode
0 0
Pulse : 0 – Tone : 1
*9
Pulse dialing mark/break ratio
0 1
Pulse 66/33 ms : 0 60/40 ms : 1
*9
3.5. Loudspeaker volume
For a better comfort, loudspeaker volume can be adjusted to 3 different levels.
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf
Loudspeaker volume
0 6
Low : 0 – Medium : 1 – High : 2
*9
In very noisy environments, an overboost reception level (+10 dB) can be selected. However, this
feature requires an external power supply (see section §
Erreur ! Source du renvoi introuvable.
)
3.6. Memory key storing
The SecurAccess comes with 1 up to 8 off-hook/memory buttons. To store the number to be dialed
when depressing one of these buttons, enter the programming mode and proceed as follows:
Setting to modify
Code
Setting choice
Factory settings are shown in grey
Conf.
M1 Key n°1 (mandatory)
2 0
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
M1 Key n°2 (mandatory)
2 5
Number to store (* # = pause) (22 digits max)
Note : no digit entered erases a previous stored number
*9
3.7. Dialing with keypad
Some models of SecurAccess series come with a front panel keypad. If you wish to dial numbers
using this keypad, you should first go off-hook by pressing a selected off-hook button that has no
