Notice SecurAccess PMR
36
6. Enter the 4 digits code within 8 seconds :
If a wrong code is entered or if it takes more than 8 seconds to enter the code, 1 “beep”
tone confirms a wrong code was entered: resume the operation at point 4.
If the code is correct, 2 “beep” tones will be emitted confirming entering the programming
mode.
Keep depressed M1 (off-hook memory button) and *
Release M1
Release *
2 “beep” tones: entering the programming mode
Enter
0000
4 digits access code (0000: factory settings)
2 “beep” tones
confirming entering the programming mode
Note:
All correct entries are confirmed by a double “beep” tone. Wrong entries are confirmed by a low long
“beep” tone and the unit will hang up.
3.2. Entering remote programming mode
1. Call the SecurAccess and wait until it automatically answers (the number of rings before
automatic answer can be changed, factory setting is 3 rings).
2.
Two “beep” tones are emitted and within the following 4 seconds, press * to enter the
programming mode (above 4 seconds, a normal communication is established). Another
double “beep” tones confirms entering the programming mode.
3. Within the following 8 seconds, enter the 4 digits programming access code (0000 with factory
settings):
If a wrong code is entered or if it
takes more than 8 seconds to enter the code, 1 “beep”
tone confirms a wrong code was entered: resume the operation.
If the code is correct, 2 “beep” tones will be emitted confirming entering the programming
mode.
Calling the SecurAccess using a Tone dialing telephone.
Dial
0XNNNNNNNN
Calling the SecurAccess
2 “beep” tones
The SecurAccess answers and goes off-hook
Enter
*
Entering the programming mode
2 “beep” tones
Confirming the entry
Enter
0000
4 digits (0000 by default)
2 “beep” tones
Confirming the entry
Note:
All correct entries are confirmed by a double “beep” tone. Wrong entries are confirmed by a low long
“beep” tone and the unit will hang up.
3.3. Programming rules
1. Enter the programming mode (local or remote)
