Notice SecurAccess PMR
29
NO/NC driving contacts for a remote and/or local activation of two door latches electrical
relays.
Selectable activation duration (from 1 up to 9 seconds)
Choice of 1 up to 6 four digits codes by door latch.
5. Local or remote programming
Local programming requires the use of a keypad and opening the unit if the model has no front
panel keypad.
Remote programming needs to call the SecurAccess using a DTM (tone) telephone.
6. Dialing Mode
Tone (DTMF) or Pulse (66/33 or 60/40 mark break ratio)
7. Conversation timer
Choice of unlimited or timed conversation (from 1 up to 9 minutes)
8. Disabled featured
(Digital announ 3 Colour icons)
Call in progress (orange colour icon)
Talk mode (blue colour icon)
Door open (green colour icon)
9. Exit button
Local activation of 1 door latch relay (1 NC driving contact).
Note: this feature is not powered by the telephone line.
10. Miscellaneous
Parameters reset (Back to the factory settings)
Hacking and hostile use protection
Programming ringer off selection
3 different programmable ringer tunes
4 digits PIN code protection
Eeprom memory backup (no need for battery or power supply backup)
Note:
In case of power supply failure, features #8 and «#9 (Disabled feature and exit button) will no longer
operate.
All other features mentioned above will still be active, (If the PSTN courant is greater than 18mA).
The unit comes out of factory with the following settings:
-
Dialing : Tone (DTMF)
-
Ringer : activated
-
Ringer melody : #2
-
Automatic answer : after 3 rings
-
Unlimited conversation time
-
No answer duration when calling : 35 seconds
-
Chain dialing : not activated
-
Door latch : not activated
-
Pin code access to programming : 0000
-
No number stored into memory button(s)