Changing the Reference Percentage
You can change the reference percentage in cycles. Choose from the
following settings: 5, 10, 20, 50 and 100.
1. Hold down FUNCTION for more than 2 seconds until “rEF 100 %”
appears on the display
2. Briefly press FUNCTION change the setting to the desired value
3. Hold down FUNCTION for more than 2 seconds to store this value
permanently (in the non-volatile memory) after you turn off the power
This setting is not canceled by the reset code 9 – – 1°!
When you exit the reference storage mode, “Err 22” may briefly
be displayed. This means that the new reference value has been
stored.
Storage Parameter for the Reference Weight/Value
The reference weight/value is stored:
- with full accuracy according to internal resolution
(Menu Code 3 5 1*)
- according to display accuracy
(Menu Code 3 5 2)
Display Parameter for Readouts in Percent
The following display parameters can be set for readouts in percent:
The readout in percent is displayed:
- without a decimal place
(Menu Code 3 6 1)
- with one decimal place
(Menu Code 3 6 2*)
- with two decimal places
(Menu Code 3 6 3*)
- with three decimal places
(Menu Code 3 6 4)
If the weight stored is too light to be displayed, the number of decimal
places is automatically decreased.
8
Memo:
Note:
