DENTSPLY AEU-25T, Operation And Maintenance Instruction Manual

Page: 4 / 20

SETTING UP THE UNIT:
1. Unpack the console and check
that the Voltage Selector is set
to the proper voltage. Use 115v
for 110-120v 60Hz voltages, and
the 230v for 220-250v 50Hz
voltages. To change the Voltage
Selector, see page 15.
2. Attach the power cord to
the back of the Console and plug
into a grounded electrical outlet.
3. Connect the AE-4B-30 motor to
the receptacle on the lower front
panel of the console.
4. Attach the “E” Type handpiece to
the motor. See Figure 2.
5. Attach the supplied AE-7P On/Off
Foot Switch to the connector on
the back of the unit marked “Foot
Switch.”
POWER
CORD
CONSOLE
MOTOR
FOOT SWITCH
“E” TYPE
HANDPIECE
MOTOR
MOTOR HOLDER
Do not attempt to operate the Endo DTC
®
while configured in the 115V mode with a
230V power source. This could damage
the electrical components and will void
the warranty.
CAUTION
Figure 1
Figure 2
STEP-BY-STEP INSTRUCTIONS