10
7. The display will show:
USE DEFAULT HP?
1=next, 2=ok, 3=esc
NOTE: The default handpiece is the
handpiece that was shipped with the
Endo DTC
®
, specified in Quick Start
Operation Section 2 on page 4.
• If you are using the default handpiece
with this file series, press Button #1 and
go on to step 8.
• If you are using a handpiece other than
the default handpiece, press Button #2.
i. The display will show:
1/8 TUL HANDPIECE or
1/8 AG HANDPIECE
1=next, 2=ok, 3=esc
ii. Press Button #1 repeatedly to cycle
through the available handpiece ratios.
When the displayed handpiece ratio
matches the handpiece ratio you are
using with this File Series, press Button
#2.
8. The Preset Button is now set with the
selected file series.
For Example 1:
The display will now show:
PROTAPER UNIVERSAL
PROTAPER S1 & SX
Pressing the Preset Button repeatedly will
cycle through the individual files in the
selected series.
9. When you have completed the customiza-
tion of the desired preset buttons, re-enable
the Preset Memory Lock to avoid
inadvertently entering the File Library during
a procedure. For instructions, read about
the System Setup Menu beginning
on page 6.
1. Disable the Preset Memory Lock.
For instructions, read about the System
Setup Menu beginning on page 6.
2. Press and hold the desired Preset Button
for 1 second (until you hear a double
beep).
3. The display will show:
ACCESS FILE LIBRARY?
1=yes, 2=no, 3=esc
Press Button #1 to access file library.
4. The display will show:
PATHFILE ALL
1=next, 2=ok, 3=esc
Press Button #1 repeatedly until the
desired file series is shown on the
display. See the Chart 3 on page 11 for a
list of available file series.
Example 1:
To go to the Protaper
®
Universal series,
press preset button #1 three times.
The display will then show:
PROTAPER UNIVERSAL
1=next, 2=ok, 3=esc
5. Press Button #2 to select the displayed
file series.
6. The display will show:
LOAD ENTIRE SERIES?
1=yes, 2=no, 3=esc
Press Button #1 to load the entire series.
9.
PROGRAMMING A PRESET BUTTON WITH AN ENTIRE FILE SERIES:
Summary of Contents for AEU-25T
Page 13: ......
