9 Performing 3D acquisition
9.3 Automatic jaw scan
Dentsply Sirona
Operating Instructions inEos X5
40
64 17 096 D3586
D3586.201.01.11.02 07.2018
9.3.1
Preparing the optical impression
In the automatic scan, you can select from the options
"Capture
Reduced" or "Capture Area".
"Capture Reduced":
The entire jaw is scanned based on a standard sequence with a
lower level of detail.
Tip: This mode is especially suitable for scanning an unprepared op-
posite jaw. It provides all of the information required for the following
steps. Hard-to-scan gaps are not automatically closed.
"Capture Area":
The area scanning option is used to define the areas in which the
scan is automatically performed with a high level of detail. The areas
of the preparations are usually the ones involved here.
All of the gaps in the digital model are closed in the scanned areas
via the intelligent gap closing technique.
All other areas of the model are scanned with a lower degree of detail
using a standard sequence.
Model holding plates
Tip: If you are using partial jaw models (e.g. quadrant models), position
these on the outer edge of the model holding plate.
ü
You have selected the desired image catalog (lower jaw, upper jaw,
etc.).
1.
Fasten the model to the supplied model holding plate using the Blue
Tack filling material. The labial side must face the straight edge of
the plate.
or
➢ Alternatively, you can use the parallel vise provided. In this case,
the labial side faces the fastening screw.
2.
Select the
"Capture Jaw" button in the Scan menu.
Ä
The articulating arm moves to the loading position.
Ä
A section of the scan area appears in the live image.
3.
Select the
"Capture Complete", "Capture Reduced", or "Capture
Area" option in the Scan menu.
Summary of Contents for inEos X5
Page 1: ...New as of 07 2018 inEos X5 Operating Instructions English...
Page 55: ......
