Dentsply Sirona inEos X5, Operating Instructions Manual

Page: 39 / 56

Dentsply Sirona
Operating Instructions inEos X5 9 Performing 3D acquisition
9.2 Starting the unit/standby mode
64 17 096 D3586
D3586.201.01.11.02 07.2018
39
Saw-cut models
● When preparing saw-cut models, be careful not to mill off the single
stump segments. Place the model next to the stumps so that the
inEos scanner can properly capture these areas.
● Create only a slight fluting below the preparation margin.
9.1.6 Autofocus
The scanner features automatic focusing.
As soon as the object stops moving, the image is automatically focused
both in the automatic and in the manual mode.
9.1.7 Deleting images
You can delete individual scans by marking them with the left mouse
button and dragging them into the recycle bin.
9.1.8 Operation via foot switch
As an alternative to the Start button of the scanner, you also can use
the optionally available foot switch (REF 63 10 449) to start and end
scanning processes in the respective scanning mode.
➢ Plug the connector of the foot switch into the matching socket (USB
port) of your PC.
9.2
Starting the unit/standby mode
The inEos X5 automatically starts (if the main switch is turned on) as
soon as you switch to the acquisition phase of the inLab SW software.
You can set the inEos X5 to standby mode and wake it up manually.
➢ To do this, click the inEos X5 icon in the bottom left window are of
the inLab SW software.
Set the inEos X5 to standby mode Activate the inEos X5
Tip: Switch off the inEos X5 via the main switch only if the inEos X5 is in
standby mode (projection lamp switched off and articulated arm in
parking position) or if no scan process has been started.
Shutdown during a running scan process causes considerable delays
when the unit is restarted.
9.3
Automatic jaw scan
Capture the model situation fully automatically in the
"Capture Jaw"
mode.
● For all tasks.
● Especially for large, complex tasks or tasks with especially high
accuracy requirements