Dentsply Maillefer X-SMART Plus, User Manual

Page: 36 / 209

FISDR-JAP / F1902124.X / 00 / 2011 – created 07/2011
- 37 / 208 -
Error
code Error Cause Check/Remedy
During
rotation of
the motor
handpiece
E-00 Self-Check Malfunction of circuit. Contact your distributor.
E-01 Over current The motor handpiece is locked
(at the time of the auto reverse
mode). Remove load.
The motor handpiece cord has
shorted.
Contact your distributor.
E-02 Over voltage Malfunction of circuit. Contact your distributor.
E-03 Motor handpiece
sensor
The motor handpiece cord is
disconnected. Connect the motor
handpiece cord correctly.
Faulty sensor (Hall IC).
Severed cord (signal line). Contact your distributor.
E-04 Overheating of
motor
High load was continuously
applied to the motor handpiece
for a relatively long period of
time.
Let the motor cool down
before resuming
operation.
E-05 PAM circuit Abnormal voltage generated in
start / stop circuit.
Faulty start / stop circuit from
PAM (L Slide). Contact your distributor.
E-06 Rotor lock The motor handpiece is locked
at the time of startup. Remove load.
Faulty contra-angle.
Motor faulty.
Faulty sensor (Hall IC).
Severed cord (Signal, Power
line).
Contact your distributor.
E-08 Over current Shorted cord (power line).
Shortstop of the motor winding. Contact your distributor.
E-09 ITRIP Faulty motor and circuit. Contact your distributor.
At the time
of charging E-10 Battery current The battery current is too low
or too high. The battery is flat
or not inserted. Put the battery into the
battery compartment or
replace the battery.
E-11 Display Faulty display driver. Contact your distributor.
E-12 Low battery voltage The battery voltage is too low.
The battery is not inserted or
the battery operating life is
over.
Put the battery into the
battery compartment or
replace the battery.
E-13 High battery
voltage
The battery voltage is too high
(circuit malfunction). Contact your distributor.
E-14 Beyond the range
of working
temperature
Beyond the range of working
temperature or damage to the
thermistor in the battery
section.
Use within the range of
working temperature or
replace the battery.