Dentech AYRDYNE 4.0, Installation, Operation And Maintenance Manual

Page: 33 / 50

www.ayrdyne.com
CONFIGURE
This button will re-download configuration.
This does not reset all parameters to
factory default. Consult the VFD manual for
instructions on how to reset all parameters
to factory default. After resetting to factory
default, make sure to press configure
button to download parameters needed for
operation of the drive. Button must be held
for 3 seconds. Indicators on the button will
turn blue once operation is complete.
MOTOR NOMINAL CURRENT (A)
This numeric entry/display shows the
motor full load amperage. Set to the motor
nameplate rated full load amps.
MOTOR NOMINAL VOLTS (VAC)
This numeric entry/display shows the motor
voltage. Set to the motor nameplate rated
volts.
AIRFLOW
31
DC LINK VOLTS (VDC)
This numeric display shows the VFD DC Bus
voltage.
OUTPUT FREQUENCY (Hertz)
This numeric display shows VFD output
frequency.
OUTPUT CURRENT (A)
This numeric display shows VFD output
current in amps.
ACTIVE FAULT
This text display shows the current status of
the VFD. If faulted, a fault code will be shown.
RESET
This button will reset VFD faults.
ACCELERATION RATE (s)
This numeric entry/display shows the
acceleration time in seconds. This value is
adjustable between 1s and 500s. Factory
default setting will vary with size of motor.
DECELERATION RATE (s)
This numeric entry/display shows the
deceleration time in seconds. This value is
adjustable between 1s and 500s. Factory
default setting will vary with size of motor.
PARAMETER NUMBER
This numeric entry/display shows which
parameter to view or edit.
PARAMETER VALUE
This numeric entry/display shows the value
of the parameter selected to view or edit.
Use caution when modifying parameters as it
may render the drive unusable.
1
2
4
3
6
5
8
7
9
2.3
10
11
12
OPERATION