DentalEZ RAM VAC COSP22S, User Manual

Page: 26 / 41

23
www.DentalEZ.com 866-DTE-INFO
23
PN: 1045DOC_E
Enable High-Pressure Mode
Section IV Operation
High-pressure mode on the Osprey compressor is
enabled by using the control buttons located on
the C2 smart control panel (Figure 13) .
To enable high-pressure mode:
1. Press NEXT button to cycle through the menu
screens. Stop at the screen that displays HI
PRESSURE MODE OFF (Figure 14) .
NOTE: This will require seven to nine presses,
based on the model of Osprey being operated.
2. Press and hold RESET button for 10 seconds.
The screen will now display HI PRESSURE
MODE ON 105 130 PSI (Figure 15) .
3. Press NEXT button. Screen will display this
warning: IN HI PRESS MODE OWL COM
DISABLED . This indicates that the On Wall
Logic (OWL) Smart Hub is in high-pressure
mode and will have limited functionality with
the compressor (Figure 16) .
Figure 14. Press NEXT button to cycle to screen
Figure 15. Press and hold RESET button for 10 seconds
Figure 16. Press NEXT button
High-pressure mode should only be activated
when supplying air to a dedicated milling
machine that requires higher pressure.
CAUTION
4. Press NEXT button again to return to the main
screen.
Figure 13. Osprey compressor C2 smart control panel
Control
Buttons
Electronic
Display