DentalEZ RAM VAC COSP22S, User Manual

Page: 14 / 41

11
www.DentalEZ.com 866-DTE-INFO
11
PN: 1045DOC_E
Section III Installation
Feet Kit
WARNING
• Prior to starting this assembly, read,
understand and follow the safety
information and the assembly instructions
in this user manual.
• Handles for lifting the compressor
assembly are provided on each end of the
device. Lifting the compressor assembly
by any other part or location could result
in damage to the compressor.
• The weight distribution of this compressor
is unbalanced to the front of the device.
Exercise care when lifting to avoid
accidental tipping and possible dropping
of the device, which could result in
damage to the compressor or severe
injuries to the installer.
• Compressor assemblies are very heavy
and may require multiple people to safely
lift. Prior to lifting, check the user manual
for the weight of this model. Over-exertion
could result in serious injuries to the
installer.
• This procedure may not comply with all
safety requirements of federal, state or
local agencies or safety requirements of
the installer’s employer. If a con fl ict does
exist, follow the requirements set forth by
the other organizations.
Parts Included
• Foot (4 Pieces)
• Flanged Nut
(4 Pieces)
Tools Required
• 7/16" Wrench
• 1/2" Wrench
Assembly
1. Remove the four nuts (7/16" wrench) from the
bolts that secure the Osprey compressor legs
to the wooden shipping pallet. At this point, the
bolts can be removed from the legs and the
compressor can be removed from the pallet.
Do not attempt to install the feet while the
compressor is on the pallet; tipping of the pallet
and subsequent loss of control may occur.
2. Lift one end of the compressor using the
integrated handles and place blocking
under the end of the tank to support the
compressor. Be careful not to damage the
drain valve under the center of the tank. Never
work under a compressor not supported with
adequate blocking (Figure 4) .
3. Thread feet into the two elevated legs from the
bottom side of the leg (Figure 4) .
Foot Flanged
Nut
Figure 3. Feet kit parts
Figure 4. Block compressor tank to install feet