DentalEZ RAM VAC COSP22S, User Manual

Page: 15 / 41

www.DentalEZ.com 866-DTE-INFO
12
Osprey
TM
Compressor
PN: 1045DOC_E
4. Adjust each foot to approximately the same
height, then thread a fl anged nut ( fl ange side
toward the leg) onto each foot (Figure 5) .
NOTE: It is not necessary to tighten the fl anged nuts
at this time. The feet will require further adjustment
once the compressor has been placed in its
permanent location in the utility room.
5. Lift the compressor and remove the blocking
from under the tank end. Repeat steps
2 through 4 for the opposite end of the
compressor.
6. After the compressor is in its permanent location
in the utility room, adjust each foot using a 7/16"
wrench until the compressor is setting level.
After adjusting the feet, tighten the fl anged nut
with a 1/2" wrench to lock the foot into position.
Section III Installation
Figure 5. Install fl anged nut
Feet Kit (Continued)
WARNING
• Prior to starting this assembly, read,
understand and follow the safety
information and the assembly instructions
in this user manual.
• The bowl on the coalescing fi lter assembly
is under high pressure while the system
is running. Allow the compressor to stop
running and release the air from the un-
loader valve prior to removing the bowl.
Failure to allow the system to properly de-
pressurize could result in severe injuries.
• Always disconnect the compressor
from the electrical power source prior to
conducting any maintenance or service
of the equipment. The compressor could
start unexpectedly, resulting in possible
injury to the service technician.
• This procedure may not comply with all
safety requirements of federal, state or
local agencies or safety requirements of
the installer’s employer. If a con fl ict does
exist, follow the requirements set forth by
the other organizations.
Parts Included
• Drain Hose
• Elbow Fitting
Elbow
Fitting
Drain Hose
Figure 6. Filter drain kit parts
Filter Drain Kit