DeLuxe Stitcher M27 Series, Operation And Maintenance Manual

Page: 11 / 44

To turn the machine manually, it
is first necessary to disconnect the
power and remove the Belt Guard
(7676), see the section “Belt Guard
Removal” on page 8. Locate the
Actuator Assembly (850992) on the
Wrap Spring Clutch (850673 or
850674) and push the Actuator so
that it pivots away from the Control
Collar Cam (850888), releasing the
Brake Hub (850892). The machine
will rotate one revolution when
the Drive Pulley (7678) is turned
manually in the direction of the
arrow on the pulley.
To tighten the V-Belt (850730C)
first loosen, but do not remove, the
four (4) Hex Nuts (HN3816) on the
Motor Mounting Plate (G30048).
Use a screw driver as a lever
between the stitcher’s frame and the
Mounting Plate to move the Plate down slightly. Pressing on the Pulley (850732) may knock it out of
position. Tighten the four (4) Hex Nuts again when the V-Belt is taut. The V-Belt should first be
tightened after two to three weeks of use and then periodically after that.
Moisture, change in temperature as well as wear can affect the tightness of the Belt. Loose Belts
can cause the Stitcher to stall and may damage the Belt permanently.
9
Cycling Machine Manually / Adjusting the V-Belt (Figure 3)
Always disconnect the power supply before
making any adjustments or servicing the stitcher.

WARNING !
Figure 3 - Turning Machine Manually / Adjusting V-Belt
7676
850677 or
850678
850888
7678
850892
850992
HN3816 (4)
G30048
11399A or
850732
LW38 (4)
PW38 (4)