PMT2 Panel Mount Power Supply
PMT2 150W series / PMT-
□
V150W2C
□□
TECHNICAL DATASHEET
All parameters are specified at 25°C ambient and nominal AC input unless otherwise indicated.
www.DeltaPSU.com (September. 2022, Rev. 02)
8
Assembly & Installation
Ⓐ
Mounting holes for power supply
assembly onto the mounting surface.
The power supply shall be mounted on minimum 2 mounting holes using M3 screw minimum 5 mm (0.20 inch) length.
Ⓑ
This surface belongs to customer’s end system or panel where the power supply is mounted.
Ⓒ
Connector
Base Mounting (Horizontal)
* If the device has to be mounted in any other orientation, please contact
•
Use flexible cable (stranded or solid) of AWG No. 18-12. User should calculate and select the suitable wire specification
(type/quantity/diameter) according to actual output current. The torque at the Connector shall not exceed 8 Kgf.cm. (6.94 Ibf.in).
The insulation stripping length should not exceed 0.275” or 7 mm. (Refer to Fig. 3).
Installation of Mounting Accessories
Fig. 3 Assembly Reference
