Delta Delta JT360, Instruction Manual, Page: 26 / 29

26
Fig. 71
REMOVING DUST CHUTE COVER
The dust chute cover (A) Fig. 71, can be removed, for
cleaning purposes, by removing the two wing screws (B).
MAKE CERTAIN THE MACHINE IS DIS-
CONNECTED FROM THE POWER
SOURCE BEFORE REMOVING THE DUST CHUTE
COVER. THE DUST CHUTE COVER (A) MUST
ALWAYS BE ASSEMBLED TO THE DUST CHUTE
DURING OPERATION.
B
Fig. 70
After considerable use, the knives will become dull and it will not be possible to do accurate work. Unless badly
damaged by running into metal or other hard material, the knives may be sharpened as follows:
WHETTING KNIVES
DISCONNECT MACHINE FROM
POWER SOURCE.
Use a fine carborundum stone, cover it partly with paper
as indicated in Fig. 70 to avoid marking the table. Lay the
stone on the infeed table, lower the table and turn the
cutterhead forward until the stone lies flat on the bevel of
the knife as shown. Hold the cutterhead from turning,
and whet the beveled edge of the knife, stroking
lengthwise by sliding the stone back and forth across the
table. Do the same amount of whetting on each of the
three knives.
OILSTONE PARTLY
COVERED WITH PAPER
IN-FEED TABLE
OUT-FEED
TABLE
CUTTER
WHETTING KNIVES
MAINTENANCE
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while
using compressed air.
FAILURE TO START
Should your machine fail to start, check to make sure the
prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers
in the line.
LUBRICATION
Apply household floor paste wax to the
machine
table and
extension table or other work surface weekly.
PROTECTING CAST IRON FROM RUST
To clean and protect cast iron tables from rust, you will
need the following materials: 1 pushblock from a jointer,
1 sheet of medium Scotch-Brite™ Blending Hand Pad, 1
can of WD-40
® , 1 can of degreaser, 1 can of TopCote ®
Aerosol. Apply the WD-40 and polish the table surface
with the Scotch-Brite pad using the pushblock as a
holddown. Degrease the table, then apply the TopCote
®
accordingly.