Delta Delta JT360, Instruction Manual

Page: 20 / 29

20
Fig. 50
Fig. 51
Fig. 52
Fig. 53
Fig. 54
ADJUSTING FENCE POSITIVE STOPS
The fence on this jointer is equipped with positive stops
that allow you to rapidly tilt the fence to the 90 and 45
degree angle to the table in the inward or outward
position. To check and adjust the positive stops, proceed
as follows:
1. Position the fence at 90 degrees to the table. Make
certain the end of plunger (A) Fig. 50, is engaged in notch
(B) in index collar as shown, and tighten lockhandle (C).
2. Place a square (D) Fig. 51, on the table and against
the fence and check if fence is 90 degrees to table.
3. If an adjustment is necessary, loosen set screw (E)
Fig. 50, in the index collar and loosen fence locking
handle (C).
4. Using the 90 degree edge of the square, tilt the fence
until you are certain the fence is 90 degrees to the table
and tighten lockhandle (C) Fig. 50, and set screw (E).
5. Loosen lockhandle (C) Fig. 52, pull out and turn
plunger (A) and tilt fence out as far as it will go. Then
tighten lock handle (C).
6. Using square (D) Fig. 52, check to see if the fence is at
a 45 degree outward angle from the table, as shown.
7. If an adjustment is necessary, loosen lockhandle (C)
Fig. 52. Loosen locknut (F) and turn adjusting screw (G)
until fence is tilted 45 degrees outward. Then tighten
locknut (F).
8. Loosen lockhandle (C) Fig. 53, and tilt fence inward as
far as possible, as shown, and tighten lockhandle (C).
9. Using a square (D) Fig. 53, check to see if the fence is
at a 45 degree inward angle to the table, as shown.
10. If an adjustment is necessary loosen locknut (J)
Fig. 54, and turn adjusting screw (H) until fence is tilted
45 degrees in. Then tighten lock nut (J).
E
B
A
C
D
C
A
G
F
D
C
D
H
J