Delta Delta JT360, Instruction Manual

Page: 11 / 29

11
Fig. 7
Fig. 8
MOTOR AND SWITCH TO STAND
1. Assemble motor (B) Fig. 7, to the bottom of the dust
chute. Align the four holes (F) Fig. 7, in the dust chute,
with the four holes in the motor mounting plate. Insert a
5/16-18x1¼"carriage bolt through hole in dust chute and
hole in motor mounting plate. Place a 5/16" flat washer
on screw and secure with a 5/16-18 hex nut. Repeat this
process for the three remaining holes.
Do not complete-
ly tighten hex nuts at this time as the motor must be
adjusted for proper alignment and belt tension later.
2. Remove M4x.7x10mm pan head screws, M4.1 flat
washers and M4x.7 hex nuts from two holes (A) Fig. 7 in
switch.
3. Insert switch assembly (C) Fig. 7 from the inside of the
stand. Align the holes (A) in the switch with the holes in
the stand (A) Fig. 8.
4. Place a M4.1 flat washer onto a M4x.7x10mm pan
head screw. Insert screw through hole (A) in stand and
switch. Thread a M4x.7 hex nut onto screw. Repeat this
process for the remaining hole in stand and switch.
C
D
B
F
F
A
A
Fig. 9C
JOINTER TO STAND
JOINTER WEIGHT IS APPROXIMATELY
175 LBS. CARE MUST BE TAKEN WHEN MOVING IT.
A MINIMUM OF TWO PEOPLE WILL BE REQUIRED
TO LIFT THE MACHINE
.
1. Turn jointer upside down so it lays flat. One way to
do this is to place the jointer tables onto two wooden
4x4s as shown in Fig. 9A.
2. Turn the stand upside down and align the threaded
holes in the bottom of the jointer with the holes in the
stand, two of which are shown at (A) Fig. 9B. The infeed
end of the jointer is fastened to the stand through these
two holes (A) Fig. 9B and (A) fig. 9C. The outfeed end of
the jointer is fastened to the stand through hole (B) Fig.
9C.
B
C
A
Fig. 9A
A
Fig. 9B