9
Fig. 12
Fig. 13
Fig. 15
Fig. 14
ASSEMBLING M O TO R
PULLEY G U A R D
M A K E C E R TAIN T H E M A C H I N E IS D I S C O N N E C T E D
F R O M T H E P O W E R S O U R C E A N D T H AT KNIFE
G U A R D (A) FIG. 13, IS POSITIONED O V E R T H E C U T-
T E R H E A D.
1.
Assemble motor pulley guard (C) Fig. 12, so it fits
around the outside of the belt and pulley guard (B). Fasten
the motor pulley guard (C) Fig. 12, to the side of the stand
with #8-32 x 1/4
round head screw (D), two flat wash-
ers, and hex nut.
ASSEMBLING F E N C E
A S S E M B LY TO JOINTER
M A K E C E R TAIN T H E M A C H I N E IS D I S C O N N E C T E D
F R O M T H E P O W E R S O U R C E A N D T H AT KNIFE
G U A R D (A) FIG. 13, IS POSITIONED O V E R T H E C U T-
T E R H E A D.
1.
Position fence slide bracket (B) Fig. 13, over the two
threaded holes (C) at the rear of the jointer and fasten
the support bracket with two cap screws (D) and supplied
wrench (E).
2.
Place fence support bracket (F) Fig. 14, over rod in
slide bracket assembly (B) and fasten with flat washer
and locking lever (G).
3.
Fig. 15, illustrates the slide and support brackets
assembled to the jointer.
4.
Align the two holes in the fence support bracket (H)
Fig. 15, with two holes (J) in fence (K) and carefully
fasten the fence to the fence support bracket with two flat
washers and 1/4-20 x 3/4
square head screws (L) as
shown in Fig. 16.
D
C
B
A
E
D
C
B
F
G
B
H
G
L
J
K
