6
Fig. 4
1. Jointer
2. Belt and Pulley Guard
3. 1/4-20 x 1/2
Truss Head
Screw (2)
4. Guard
5. #8-32 x 1/4
Round Head
Screw
6. Flat Washers (2)
7. #8-32 Hex Nut
8. Dust Chute
9. Cutterhead Guard
U N PACKING A N D CLEANING
The 6
Motorized Jointer is shipped complete in one container. Carefully unpack the jointer, stand, and all loose items
from the container. Figs. 4 and 5 illustrate the items supplied with the jointer.
1.
W ARNING: For your own safety,
DO NOT connect the jointer to a power source until the machine is completely
assembled and you have read and understood the entire owner s manual.
2.
IMPORTA N T:When removing the jointer from the shipping container,
D O N O T place the jointer on a flat surface.
Support the jointer at both ends with 4
x 4
lumber or similar material, as shown in Fig. 4. This will prevent any dam-
age to the motor assembly, which is located on the base of the jointer.
3.
CAUTION: Carefully remove the protective coating from the machined surfaces of the jointer.
D O N O T let
your
hands or fingers come in contact with the cutterhead knives as they are extremely sharp. D O N O T use acetone, gaso-
line or lacquer thinner to clean the jointer; use a soft cloth moistened with kerosene. After cleaning, cover the table sur-
face with a good quality paste wax.
10. Fence Mounting Bracket
Assembly
11. Locking Lever
12. Flat Washer
13. 1/4-20 x 3/4
Flat Head
Screws (2)
14. Flat Washers (2)
15. 1-1/4-20 Hex Nuts (2)
16. Fence Support Bracket
17. Cap Screws (2)
18. 5/16-18 x 1-1/4
Hex Head
Screws (3)
19. Flat Washers (6)
20. 5/16
Hex Nuts (3)
21. Push Blocks (2)
22. Fence
23. Flat Washers (2)
24. 1/4-20 x 3/4
Square Head
Screws
25. W renches (4): 2.5, 5, 6mm
and 8/10mm Open-end
1
18
20
19
17
21
22
16
25
23
24
9
8
2
12
11
15
10
14
13
3
4
5
7
6
