9
ATTACH FRONT PANEL TO
BASE (FIg. 12–15)
1. Place 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
2. Line up holes in front panel (N) with holes in base
plate (S), as shown in Figure 12.
NOTE:
Be sure front panel is oriented as shown in
Figure 13.
3. Place hex head bolt and washer assembly through
holes in front panel (N) and base plate (S).
4. From underneath the base secure front panel to
base using a 5/16" hex nut (Q).
5. Repeat for other hole in front panel and base.
6. The front and side panels are shown correctly
assembled in Figure 15.
NOTE:
FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
ATTACH MOTOR/BLOWER
TO STAND (FIg. 16, 17)
1. Place motor/blower housing on top of stand. Align
holes (T) in the housing with holes (U) in the stand.
2. Place 5/16" lock washer (K) on 5/16" x 3/4" (19 mm)
hex head bolt (L).
3. Insert this washer/bolt assembly up through holes
(U) in stand and insert bolt into the threaded holes
(T) of the motor/blower housing. Hand tighten only.
4. Repeat for five remaining holes.
NOTE:
FASTEN ALL HARDWARE HAND TIGHT ONLY AT
THIS POINT. Hardware will be tightened later in a certain
order.
FIg. 12
L
K
S
N
FIg. 13
FIg. 16
FIg. 17
T
U
L
K
FIg. 15
FIg. 14
Q
