11
FIg. 22
ATTACHINg HANDLE (FIg. 22–26)
1. Attach handle retaining clip (X) into second hole (Y)
from the top of the front panel.
2. Orient the clip (X) as shown in inset, with the
opening facing away from the dust collector.
3. Repeat for the other retaining clip on the other side
of the front panel.
4. Orient the handle as shown in Figure 23.
5. Place ends of handle (Z) through the lower holes on
both sides of the front panel, as shown in Figure 23.
6. Clips should hold handle, as shown in Figure 24.
7. Push the non-removable retaining nuts (AA) firmly
onto the ends of the handle that stick inside of the
front panel.
NOTE:
These nuts (AA) are non-removeable. Make
sure the handle is properly oriented before installing
them.
X
X
Y
Z
FIg. 23
FIg. 24
AA
AA
FIg. 25
FIg. 26
