Tutorial
1) Sensor wiring help
1. Start the
DL2e Program
Editor
.
2. Select
Sensor Library.
3.
Scroll down to and click on any
sensor. An
Application Notes
window
will open with wiring instructions for each
sensor and input card.
4.
See if you can find suitable
instructions for the components in the
Tutorial kit.
2) Connect Tutorial Kit sensors
1. Remove the sensor terminal blocks from the side of the logger, and attach the
Tutorial Kit components as shown here, using the screwdriver provided:-
2. Plug the terminal blocks back in to the terminal panel.
OFF
1 2
3. Set the two slider switches UP to the ON position (top right of terminal board) to
connect channel 1 to a thermistor on the terminal board. It can be used as the cold
junction reference for thermocouples.
3) Set up LAC1 Input Card
Open the logger and ensure that:
an LAC1 card is installed with slider switch set to 15-Ch
a ribbon cable connects from the 15 channel terminal on the LAC1 card
to the terminal block for channels 1-15 inside the logger.
© 2006 Delta-T Devices Ltd
v1.1 Page 5
