Page.34.
status is“×”, means the IP address is available
Application
：
Add an IP camera or other network device to the current network group, the new IP address must not be
occupied, otherwise it will cause IP conflicts and stop the equipment normal working. Link monitor can
check if the new setting IP address is occupied.
3.3.18IP address scan
Connect the cable to the LAN port, press to select press to enter. Press to
“SetIP”, press to set the local IP address, the network segment and the network devices must be
consistent. After setting, move the cursor to “Start”, press to scan the IP camera or other network
equipment address.
3.3.19 PoE tester
Press to select , and then press to enter. Connect the cable to the power
supply equipment’s POE port and the tester’s PSE IN port. Connect IP camera or wireless AP
equipment connect tester’s LAN port, the POE voltage and the cable’s pin connection status show on
the screen.
