EN
16
17
If the motor is not working:
- Check that the wiring corresponds to the diagrams in the “Connection” chapter.
- Check the power supply in the network.
- Check that the motor is not in thermal protection mode; just wait a few minutes
for it to cool down.
- Check whether there is a problem linked to the end of travel settings and
reset them.
The end of travel points are not applied:
- Check the mechanical components of the system
(stabilisation, play, distortion, etc.)
- Check whether there is a fault linked to the end of travel settings and reset them.
Reversal of the direction of rotation when the stops are already set.
- Raise the shutter completely,
- Press
O
(STOP) within 5 seconds following the stop of the shutter,
- Then perform the following sequence:
O
O
O
O
(at <3 second intervals), then long press on .
The motor briefly starts twice.
Check the direction of rotation of the motor.
5/ Troubleshooting
