6
7
INSTALLATION FROM BELOW - NO NEED FOR SUSPENSION BRACKETS (NO ATTIC ACCESS)
BEFORE INSTALLATION
Turn off power source. Review all safety precautions.
1. Measure the opening to ensure it is large enough to
accommodate the new fan housing (A) (10 1/4 in. x 10
1/4 in.).
If this fan is not replacing an old fan, be sure to cut a
10 1/4 in. x 10 1/4 in. opening for the fan housing (A).
NOTE: One edge of the 10 1/4 in. x 10 1/4 in. cut out
must be a long the joist for proper installation. If not
possible, then attic access and brackets will need to be
used (see step 2 on page 10).
2. Remove fan motor (2.1) from fan housing (A) by
removing the screws where shown (2.2). Gently pull
the motor out from the fan housing.
3. Remove duct connector (3.1) by removing the duct
connector screw (3.2) on the fan housing (A).
EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
4
5
6
7
8
9
10
11
1
A
2.1
2.2
2.2
2.2
A
3.2
3.1
1
2
3
10 1/4"
10 1/4"