15
• ESPRESSO
•
• COFFEE
• LONG
• AMERICANO
• 2X ESPRESSO
6. Preparation begins. An image of the selected beverage ap-
pears on the display (B), together with a progress bar which
gradually fills as preparation proceeds.
Please note:
• You can prepare 2 cups of ESPRESSO coffee at the same
time by pressing "2X
" during preparation of 1 ESPRES-
SO (the image is displayed for a few seconds at the start of
preparation).
• While the machine is making coffee, delivery can be inter-
rupted at any moment by pressing "
".
• As soon as delivery has ended, to increase the quantity of
coffee in the cup, just press "
". When the re-
quired quantity is reached, press "
".
Once the coffee has been made, the appliance is ready to make
the next beverage.
Please note!
• Various alarm messages could be displayed while using
the appliance (FILL TANK, EMPTY GROUNDS CONTAINER,
ETC.). Their meaning is explained in section “24. Displayed
messages”.
• For hotter coffee, see section “9.2 Tips for a hotter coffee”.
• If the coffee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in sections “9.1
Adjusting the coffee mill” and “25. Troubleshooting”.
• Preparation of each coffee can be customised (see sections
“16. Customising the beverages” and “17. Memorising your
personal profile”).
9.6 Making coffee using pre-ground coffee
Important!
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty it.
This could damage the appliance.
• Never use more than 1 level measure (C2) or it could dirty
the inside of the coffee machine or block the funnel (A4).
Please note!
If you use pre-ground coffee, you can only make one cup of cof-
fee at a time.
1. Press "
AROMA" (B6) repeatedly until "
" (pre-
ground) appears on the display (B).
2. Open the pre-ground coffee funnel lid (A2).
3. Make sure the funnel (A4) is not blocked, then add one level
measure of pre-ground coffee (fig. 14).
4. Place a cup under the coffee spouts (A8) (fig. 13).
5. Then select your required coffee (ESPRESSO, COFFEE, LONG,
AMERICANO);
6. Preparation begins. An image of the selected beverage ap-
pears on the display, together with a progress bar which
gradually fills as preparation proceeds.
Important! Making
LONG coffee
:
Halfway through preparation, the message "ADD PRE-GROUND
COFFEE, MAXIMUM ONE MEASURE" IS DISPLAYED. Add one
level measure of pre-ground coffee and press "
".
Please note!
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.
10. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note!
To avoid milk with poor froth or large bubbles, always clean the
milk container lid (D2) and hot water connection nozzle (A9) as
described in sections “4.1 Cleaning the milk container after use”,
“10.1 Cleaning the milk container” and “8.1 Cleaning the hot
water/steam connection nozzle”.
10.1 Filling and attaching the milk container
1. Remove the lid (D2) (fig. 15);
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the contain-
er (fig. 16). Each mark on the side of the container corre-
sponds to about 100 ml of milk;
Please note!
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
• If "Energy Saving" mode is enabled, you may have to wait a
few seconds before the beverage is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
the bottom of the milk container lid (fig. 17);
4. Place the lid back on the milk container;
5. If present, extract the hot water/steam spout (C6) by press-
ing the release button (C7) (fig. 18);
6. Attach the milk container (D) to the connection nozzle (A9)
(fig. 19) and push as far as it will go. The machine emits a
beep (if the beep function is enabled);
7. Place a sufficiently large cup under the coffee spouts (A8)
and frothed milk spout (D5). Adjust the length of the milk
spout. To move it nearer the cup, simply pull it downwards
(fig. 20).
8. Follow the instructions below for each function.
