15
NOTICE: noise level. After setting up your
machine, you may notice an increase of the
noise level for a few seconds. This is not due
to a defect in the machine but to the water
starting to circulate for the first time. Should
the noise continue for more than 15 seconds,
check that the suction inlet tube is correctly
connected to the motor unit. When the water in
the tank runs out, the noise level will increase
once again. At this point, switch off the
machine and proceed to refill the tank as
described in the instruction booklet.
Important: the pump noise level acts as an acou-
stic warning that the water in the tank has run
out.
Window cleaning attachment
(where supplied)
For instructions on how to use this attachment,
refer to the instructions supplied with it (fig.13).
Plug in the appliance.
Operate the pump, pressing the pump button
(fig.14).
General tips
To remove particularly stubborn dirt,
proceed as follows:
- Turn the selector (9) to extraction
cleaning .
- Depress the pump button only and use
the spray trigger (16) to spray shampoo
solution on the surface to be treated.
- Wait one or two minutes to allow the
shampoo to soak in completely.
1
OPERATING THE APPLIANCE
Extraction cleaning
The shampoo solution is sucked up from the
tank by a pump and sprayed through a nozzle
onto the surface to be cleaned; the shampoo
penetrates the fibres, dissolving even the
most stubborn dirt. The transparent wash-dry
attachment vacuums up the dirty water, which
is then collected in the wet tank, leaving the
surface clean and almost dry. Extraction
cleaning deep-cleans rugs, carpets, fabrics
and floors, restoring their colour, improving
their appearance and making them last
longer.
CAUTION: never press the pump button
when the shampoo solution tank is empty
or when the cleaner is being used as a wet
or dry vacuum cleaner. In the event that the
pump is used incorrectly (appliance
operated without shampoo for more than 15
minutes) a safety device automatically
shuts off the pump to prevent damage.
When this happens, wait 30 minutes before
starting up the appliance again.
13
14
11/19 Penta GB 11-01-2001 08:20 Pagina 15
