DeLonghi La Specialista EC933 Series, Instructions For Use Manual

Page: 13 / 19

13
4. Turn the fineness selector anticlockwise as far as it will go
to the "REMOVE" position
(fig. 41).
42 41
5. Lift and extract the upper burr
, taking it by the special han-
dle (fig 42).
6. Clean the inside of the appliance with the tube brush
(C8)-
fig. 43)
and use a vacuum cleaner to remove coffee residues
(fig. 44).
43 44
7. Put the upper burr back in the appliance
:
45 46
• Insert the brash in its housing (fig. 45);
• Turn the fineness selector to the desired grinding position
(fig. 46);
• verify that the burr is well inserted by pulling it by the han-
dle: the burr is correctly inserted if it does not move;
8. Use a brush to remove any coffee residues from the outlet
of the coffee mill
(A22).
11.9 Extra grinding adjustment
Over time, the burrs will wear down and the quantity of ground
coffee will diminish. When the grinding adjustment illustrated
on the "6.4 Select the grinding level" is not sufficient, you can
select a new grinding range. Proceed as follows:
1. Press and hold the
(B3) and (B7) buttons together
for at least 3 seconds to access the menu. The (B15)
and (B16) lights alternate;
2. turn the mode selector dial (B8) to the position: the
(B14) light remains on steady.
3. Select the new grinding range by pressing the (B4)
button;
4. Press the (B1)button to exit the menù. (If the appliance
is left idle for about 1 minute, it exits automatically from
the settings menu and is ready for use again);
5. Turn the dial (B2) to position ("min"), then proceed as
illustrated for the first use ("6.4 Select the grinding level").
Over time, the burrs will wear down and the quantity of ground
coffee will diminish. If this occurs, replace with new burrs pur-
chased from an authorised Customer Services centre.
Then turn the knob (B2) to
(min) position and proceed as
illustrated at the first use ("6.4 Select the grinding level").
11.10 Cleaning the "tamping station"
47 48
1. Clean the attachment area with a brush (fig. 47).
2. Pull the lever
(A23)as far as it will go and clean the presser
cylinder with a brush (fig. 48). Then release the lever;
3. Use the tube brush
(C8)
to clean the coffee guide
(fig. 49).