DeLonghi ESM 495 ST, User Operating Instructions Manual, Page: 14 / 24

NORMAL COOKING WITHOUT THE USE OF THE PROGRAMMER
To manually use the oven, without the aid of the programmer, it is necessary to cancel
the flashing
AUTO by pushing the button ( AUTO will be switched off and the
symbol will illuminate).
Attention: If the AUTO is illuminated (which means a cooking program has already
been inserted), by pushing the button you will cancel the program and revert to
manual operation.
If the oven is switched on, remember you must switch off manually.
ELECTRONIC TIMER
The timer program consists only of a buzzer which may be set for a maximum period
of 23 hours and 59 minutes.
To set the time, push the
button and the or until you obtain the desired time
in the panel (fig. 9). Having finished the set-
ting, the clock hour will appear on the panel and the
symbol will be illuminated.
The countdown will start immediately and may be seen at any moment on the panel
by simply pressing the button
. At the end of the time, the symbol will disappear
and the buzzer will sound and continue for approximatley 7 minutes or until a button
is pressed (not the
/ buttons). After a short period of time the display will revert
back to the time of day.
SETTING THE FREQUENCY OF THE AUDIBLE SIGNAL
The buzzer has 3 different tones and can be changed by pressing the button, but
only when the time of day is displayed.
SETTING THE AUTOMATIC OVEN COOKING
To cook food automatically in the oven, it is necessary to:
1. Set the length of the cooking period
2. Set the end of the cooking time
3. Set the temperature and the oven cooking program.
These operations are done in the following way:
1. Set the length of the cooking period by pushing the button and the button
to increase, or to decrease if you have passed the desired time.
The AUTO and the symbol will be illuminated.
2. Set the end of the cooking time by pressing the button (the cooking time already
added to the clock time will appear), and the button; if you pass the desired
time you may get back by pushing the button.
After this setting, the symbol will disappear. If after this setting, the AUTO flash-
es on the display and a buzzer sounds, it means there was an error in the program-
ming,
14