33
7. When the required froth is obtained, interrupt
steam delivery by pressing the button.
Important! Danger of burns
Stop steam delivery before removing the contai-
ner with the frothed milk to avoid burns caused by
splashes of boiling milk.
8. Add the milk froth to the coffee prepared pre-
viously. The cappuccino is ready. Sweeten to
taste and, if desired, sprinkle the froth with a
little cocoa powder.
Cleaning the cappuccino maker
after use
Clean the cappuccino maker each time you use it
to avoid the build-up of milk residues or blocka-
ges.
Important! Danger of burns.
When clea-
ning the cappuccino maker, a little hot water
comes out (B5). Avoid contact with splashes of
water.
1. Flow off a little water or steam for a few
seconds by pressing the button.
Press the button again to stop the flow of
steam/hot water.
2. Wait for a few minutes for the cappuccino
maker to cool down, hold the handle of the
cappuccino tube in one hand and with the
other rotate the cappuccino maker anticlock-
wise (fig. 15) then remove by pulling down-
wards (fig. 16).
3. Wash all parts of the cappuccino maker tho-
roughly with warm water.
4. Make sure the two holes shown by the arrows
in fig. 17 are not blocked.
If necessary, clean with a pin.
5. Replace the inner section by inserting it care-
fully onto the adjustable tube, then insert the
steam nozzle and turn anticlockwise to lock it
in place.
HEATING WATER
Important! Danger of burns.
Never leave
the machine unsupervised while delivering hot
water. Stop delivery of hot water as described
below when the cup is full. The hot water spout
becomes hot while water is being delivered and
must be held by the handle only.
1. Place a container under the spout (as close as
possible to avoid splashes).
2. Press the button. The light comes on.
3. Press the button (fig. 3), then interrupt
by pressing the same button again or wait
until the customised quantity has been delive-
red.
Important:
You should not deliver hot
water for more than 3 minutes at a time.
Customising hot water quantity
To customise the quantity, proceed as follows:
1. Position a container under the spouts.
2. Press and hold the button down for at least
8 seconds.
Delivery begins and the light flashes.
•
When the hot water in the cup reaches the
required level, press the button again.
The machine is now reprogrammed with the new
quantity.
GB
