Cleaning the coffee feed funnel
•
Check regularly (about once a month ) that
the pre-ground coffee funnel is not blocked.
If necessary, remove coffee deposits with a
kitchen knife.
Cleaning the inside of the machine
1. Check regularly (about once a week) that the
inside of the machine is not dirty.
If necessary, remove coffee deposits with a
toothpick, sponge or stiff bristled kitchen
brush.
2. Remove the residues with a vacuum cleaner
(fig. 23).
Cleaning the infuser
The infuser must be cleaned at least once a
month.
Important!
The infuser (A8) may not be
removed when the appliance is on. Do not attempt
to use force to remove the infuser as this could
damage the machine.
1. Turn the appliance off by pressing the
button. When the appliance has gone off,
unplug.
2. Open the service door (fig. 19);
3. Remove the drip tray and grounds container
(fig. 20);
4. Press the two red release buttons inwards and
at the same time pull the infuser outwards
(fig. 24).
Important!
Do not use washing up liquid to
clean the infuser (A8). The detergent would remo-
ve the lubricant applied to the inside of the piston,
causing the infuser to seize up and become unu-
sable.
5. Soak the infuser in water for about 15 minu-
tes, then rinse.
6. After cleaning, replace the infuser (A8) by sli-
ding it onto the internal support and pin at the
bottom, then push the PUSH symbol fully in
until it clicks into place.
NB!
If the infuser is difficult to insert, you
must first adapt it to the right size by pressing it
forcefully from the bot-
tom and top as shown
in the figure.
7. Once inserted, make
sure the two red
buttons have snap-
ped out.
8. Replace the drip tray
(A11) and grounds
container (A9).
9. Close the service door
(A12).
DESCALING
Descale the appliance when the light flashes.
Important!
Descaler contains acids which
may irritate the skin and eyes. It is vital to respect
the manufacturer’s safety warnings given on the
descaler pack and the warnings relating to the pro-
cedure to follow in the event of contact with the skin
and eyes.
NB!
Failure to descale the appliance as
described above invalidates the guarantee.
1. Turn the machine on.
2. Press the P button to enter the menu.
3. Turn the selector knob until the light flas-
hes.
4. Select by pressing the button: The
OK light flashes.
5. Press the button to activate the func-
tion. The light flashes and the OK light
comes on.
6. Empty the water tank (A7) and remove the
35
Pin
Support
GB
