15
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (fig. 28);
28
29
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 29) and pull off upwards;
4. In a dishwasher (recommended): Rinse all components
and the container with hot running water (at least 40°C),
then place them in the top basket of the dishwasher and
run a programme at 50°C, e.g. standard ECO. By hand:
Rinse all components and the container with hot running
water (at least 40°C), then immerse all the components in
hot tap water (at least 40°C) with a mild/neutral wash-
ing-up liquid for at least 30 minutes. Rinse thoroughly
with hot tap water.
30
31
5. Rinse inside the froth adjustment dial seat with running
water (fig. 31);
6. Check that the intake tube and milk spout are not clogged
with milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
16.11 Cleaning the hot water nozzle
Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (fig.
20).
17. DESCALING
Important!
• Before use, read the instructions and the labelling relative to
the descaler product, which are indicated on the pack (includ-
ed with certain models and/or available for purchase from
authorized service centres).
• Use De’Longhi descaler only. Using unsuitable descaler
and/or performing descaling incorrectly may result in
faults not covered by the manufacturer’s guarantee.
Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler
De’Longhi “EcoDecalk” descaler
Container
Recommended capacity: 1.8
Time
~45min
Descale the machine when the indicator (B5) lights up on
the panel.
To proceed with descaling immediately, if preferred, follow the
instructions from point 1. To postpone the descaling procedure
until later, press
ESC
(B14): the indicator (B5) on the touch
screen remains alight as a reminder that the appliance needs to
be descaled.
To start the descaling procedure:
1. Take out the water tank (A17), remove the water softener
filter (C4) and empty the water from the tank.
2. Pour the descaler into the tank up to level A (corresponding
to a 100 ml pack) marked on the inner surface of the tank
(fig. 32), then add water (1 litre) up to level
B
(fig. 33) and
put the water tank back.
B
A
A
B
A
B
32
33
3. Remove, empty and replace the drip tray (A15) and the
grounds container (A11).
