18
The infuser has not been replaced
after cleaning
Insert the infuser as described in the section
“Cleaning the infuser”
The grinding is too fine and the
coffee is delivered too slowly or
not at all
Repeat coffee delivery and turn the grin-
ding adjustment knob (fig. 10) one click
clockwise towards “7” while the coffee mill is
in operation.
If after making at least 2 coffees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment knob another
click until delivery is correct (see the section:
Adjusting the coffee mill on page 11).
If the problem persists, turn the steam knob to
the I position and deliver water from the cap-
puccino maker.
Pre-ground function was selected
but no pre-ground coffee was
poured
Pour pre-ground coffee in the coffee funnel.
Pre-ground coffee is blocked in the
funnel
Clean the preground coffee funnel (see page
14)
Too much coffee has been used
Select a milder taste or reduce the quantity of
pre-ground coffee then make the coffee again.
The water circuit is empty: it is ne-
cessary to insert the water spout
Insert the water spout and deliver hot water
The water circuit is empty
Press OK to deliver water from the spout (E3)
until it flows out normally. If the problem per-
sists, make sure the water tank is fully inserted.
