DeLonghi ECAM22.32 Series, Instructions For Use Manual

Page: 17 / 20

16
Please note :
The filter lasts about two months if the appliance is used
normally. If the coffee machine is left unused with the filter
installed, it will last a maximum of three weeks.
3. To activate the filter run tap water into the hole as
indicated in the diagram letting the water run out of the
side openings for at least one minute (fig. 29).
4. Take out the tank from the appliance and fill with water.
5. Place the filter in the water tank and submerge it
completely for ten seconds, tilting it to enable the air
bubbles to escape (fig. 30).
6. Insert the filter into the filter housing and press as far as it
will go (fig. 31A).
7. Close the tank with the lid (fig. 31B), and then replace the
tank in the machine.
When you install the filter you must notify the appliance of its
presence.
8. Press the
MENU button to access the menu;
9. Press the or button repeatedly until “Install
filter” is displayed.
10. Press the button .
11. The message “Enable?” appears on the display.
12. Press the
button to confirm selection. “TURN STEAM
KNOB” appears on the display.
13. Place a container under the cappuccino maker (min.
capacity of 100 ml).
14. Turn the steam knob (fig. 5). “HOT WATER Confirm?” is
displayed.
15. Press the button to confirm selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
16. Once delivery is completed, “TURN STEAM KNOB” is
displayed.
17. Turn the steam knob to the 0 position (fig. 5). The appliance
automatically resets to “Coffee ready” status.
The filter is now active and indicated by an asterisk displayed
in the menu under the item “Install filter”. You can now use the
coffee machine.
Replacing the filter
When the message “Replace filter” is displayed or after two
months (see date indicator) or when the appliance has not been
used for 3 weeks, you should replace the filter.
1. Remove the water tank and used up filter;
2. Take the new filter out of its packet and proceed as
illustrated in points 3, 4, 5 and 6 in the previous section.
3. Place a container under the cappuccino maker (min.
capacity of 100 ml).
4. Press the
MENU
button to access the menu;
5. Press the or button repeatedly until “Replace
filter” is displayed.
10. Press the button;
11. The message “Confirm?” is displayed.
12. Press the
button to confirm selection. “TURN STEAM
KNOB” appears on the display;
13. Turn the steam knob. “HOT WATER Confirm?” is displayed.
14. Press the
button to confirm selection. The appliance
begins hot water delivery and the message “Please wait” is
displayed.
15. Once delivery is completed, “TURN STEAM KNOB” appears
on the display. Turn the steam knob to the 0 position. The
appliance automatically resets to “Coffee ready” status.
The new filter is now active and you can use the coffee machine.
Removing the filter
If you want to continue use the appliance without the filter, you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Remove the water tank and used up filter;
2. Press the
MENU
button to access the menu;
3. Press the or button repeatedly until “Install
filter” is displayed.
4. Press the button ;
5. The message “Disable?” appears on the display;
6. Press the
button to confirm and the MENU button
to exit the menu.
TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power: 1450W
Pressure: 15 bar
Max. capacity water tank: 1,8 litres
Size: LxHxD: 238x345x430 mm
Cable length: 1,15 m
Weight: 9,1 Kg
Max. capacity beans container: 250 g
The appliance complies with the following EU directives:
• EC Regulation 1275/2008 for standby;
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• All materials and accessories coming into contact with food
conform to EC regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.