25
PROBLEM
POSSIBLE CAUSE
REMEDY
The coffee is delivered too slowly or a
drop at a time.
The coffee is ground too finely.
Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coffee
mill is in operation (fig. 13). Continue one click
at a time until the coffee is made satisfactori-
ly. The effect is only visible after delivering 2
coffees (see section "7.5 Adjusting the coffee
mill").
Coffee does not come out of one or
both of the spouts.
The coffee spouts (A9) are blocked.
Clean the spouts with a toothpick (fig. 25B).
The appliance will not make coffee
The appliance has detected impurities
in its internal circuits. "Cleaning under-
way" is displayed.
Wait for the appliance to be ready again and
reselect the required beverage. Contact Cus-
tomer Services if the problem persists.
The appliance does not come on
The power cord connector (D7) is not
inserted correctly.
Insert the connector as far as it will go in the
socket at the back of the appliance (fig. 1).
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A22) is not turned on. Press the main switch (fig. 2).
The infuser cannot be extracted
The appliance has not been turned off
correctly
Turn the appliance off by pressing the
but-
ton (A15) (see section "5. Turning the appliance
off").
At the end of descaling, the appliance
requests a third rinse
During the two rinse cycles, the water
tank (A17) has not been filled to the
MAX level
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A15) to avoid
the water overflowing.
Milk does not flow from the milk
spout (E5)
The milk container (E) lid (E2) is dirty
Clean the milk container lid as described in
section "12.10 Cleaning the milk container".
The milk contains large bubbles and
squirts out of the milk spout (E5) or
there is little froth
The milk is not cold enough or is not
semi-skimmed or skimmed.
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as expected, try a different brand of milk.
The froth adjustment dial (E1) is incor-
rectly adjusted.
Adjust following the instructions in section "9.
Making cappuccinos and milk-based coffees".
The milk container lid (E2) or froth ad-
justment dial (E1) are dirty
Clean the milk container lid and control knob
as described in the section "12.10 Cleaning the
milk container".
The hot water connection nozzle (A8)
is dirty
Clean the connection nozzle as described in
section "12.11 Cleaning the hot water nozzle".
The machine emits noises or small
puffs of steam while not in use
The machine is ready for use, or has re-
cently been turned off, and condensate
is dripping into the hot vaporiser
This is part of normal operation. To limit the
phenomenon, empty the drip tray.
