4. Disassembly and Assembly Procedures
Plug 2pcs panel lamp cables to the connectors of
the circuit board, then fix the cables with tapes
pasted on the panel module.
Take 1pcs function key board and 1pcs middle bezel,
and then locate the function board into the specific
position of the middle bezel. Put the unit into a fixture,
use
Paste 1pcs mylar tape to cover the
function key board.
a Philips-head screwdriver to tighten 3pcs
screws for locking the function key board with the
middle bezel.
(No.1~3 Screw size= M2x2.4, Torque=0.8
±0.2
kgfxcm)
Adjust the bracket chassis module, and then u
.
se a
Philips-head screwdriver to tighten 4pcs screws for
locking the bracket chassis module with the panel
(No.1~4 Screw size= M6x12, Torque=9
±
0.5
kgfxcm)
2
3
4
1
Take 1pcs small bracket to assemble with T-Con
board, then use
a Philips-head screwdriver to tighten
2pcs screws for locking the small bracket with T-Con
board.
(No.1~2 Screw size= M3x0.5x4, Torque=3
~5
kgfxcm)
S8
Move the bracket chassis module close to the panel
module, then connect the LVDS cable to the
connector of the T-Con board, then put the bracket
on the back of the panel module.
2
1
S9
S10
S11
S12
1
2
3
Turn over the panel module to place screen faced
down. Paste 2pcs shading tape on the left and right
side of the panel corner, then paste 32pcs acetate
tapes on the specific position of the back of panel as
the picture below shown.
S7
