5. Trouble Shooting Instructions
Self-Test
Your monitor provides a self-test feature that allows you to check whether your monitor is
functioning properly. If your monitor and computer are properly connected but the monitor
screen remains dark, run the monitor self-test by performing the following steps:
1
Turn off both your computer and the monitor.
2
Unplug the video cable from the back of the computer. To ensure proper Self-Test
operation, remove all digital and the analog cables from the back of computer.
3
Turn on the monitor.
The floating dialog box should appear on-screen (against a black background), if the monitor
cannot sense a video signal and is working correctly. While in self-test mode, the power LED
remains white. Also, depending upon the selected input, one of the dialogs shown below will
continuously scroll through the screen.
Dell UltraSharp 43 Monitor
The display will go into Standby Mode in 4 minutes.
No HDMI Cable
www.dell.com/support/U4320Q
U4320Q
or
Dell UltraSharp 43 Monitor
The display will go into Standby Mode in 4 minutes.
No DP Cable
www.dell.com/support/U4320Q
U4320Q
or
Dell UltraSharp 43 Monitor
The display will go into Standby Mode in 4 minutes.
No USB Type-C Cable
www.dell.com/support/U4320Q
U4320Q
4
This box also appears during normal system operation if the video cable becomes
disconnected or damaged.
5
Turn off your monitor and reconnect the video cable; then turn on both your
computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check your video
controller and computer, because your monitor is functioning properly.
