4. Disassembly and Assembly Procedures
4
.2 Assembly Procedures:
Put 1pcs power board into the bracket, then use a
Philips-head screwdriver to tighten 5pcs screws for
locking the power board.
(No.1 screw size=M4x8, Torque=6
±0.5
kgfxcm;
No.2~5 screw size=M3x7.5, Torque=6
±0.5
kgfxcm)
Place a bracket chassis base on a protective
cushion, then stick 3pcs Silicon sheets on the
position as the picture below shown.
S2
S1
Use a
two screws
for locking the AC-power outlet connector.
Philips-head screwdriver to tighten
(No.1~2 screw size=M3x8, Torque=6~8kgfxcm)
S4
Take 1pcs interface board, connect a LVDS cable to
the connector of the interface board, then connect
the power connective cable to the the interface
board. Turn over the interface board and locate it into
the bracket. Use a Philips-head screwdriver to tighten
4pcs screws for locking the interface board.
(No.6~9 screw size=M3x7.5, Torque=6
±0.5
kgfxcm)
S3
7
9
2
1
Panel preparation: Take out 1pcs panel module from
the carton, remove the protective film by tearing off
all the tapes of screen and four sides, then examine
the panel surface according to inspection criteria
carefully.
S5
2
4
1
3
5
6
8
Take 1pcs Dell nameplate, then use a locating fixture
to fix the nameplate to the front bezel of the module,
and then move the whole unit into a laminating
fixture, use the laminating fixture to press the
nameplate with the front bezel of the panel module
firmly attachment.
S6
