1-4
QLogic QLA2100 Host Bus Adapter Card Installation Guide
&KDQJLQJWKH195$0IRU8VH:LWKD'HOO3RZHU9DXOW
))RU)5$,'6WRUDJH6\VWHP
If you are using the host adapter card with a JBOD storage system and you need to
connect a RAID storage system to the card, perform the following steps to reconfig-
ure the cards NVRAM settings:
1.
Insert the
QLogic drivers and firmware update diskette
into the systems diskette
drive and boot the system.
2. When the
D?
prompt appears, type
FGQYUDP?UDLG
and press <Enter>.
3. Type
TO[XWLO
and press <Enter>.
A list appears showing the addresses of the host bus adapters installed in the
system.
4. Type the correct adapter address and press <Enter>.
5. Press <L> and then press <Enter> to write the NVRAM.
6. Repeat steps 3, 4, and 5 to update the NVRAM of any other host bus adapters
installed in the system.
7.
After you finish updating the NVRAM for all host bus adapter cards in the system,
you must turn off and then turn on the system for the changes to take effect.
