Display Bezel
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
central control cover
.
3.
Remove the
display assembly
.
4.
Use a plastic scribe to pry the eight display bumpers out of the screw holes located on the front of the bezel.
5.
Remove the eight M2.5 x 6-mm screws located on the front of the bezel.
6.
Starting at the bottom of the display panel (by the Dell™ logo), use your fingers to separate the bezel from the top cover by lifting the inside edge of
the bezel away from the top cover.
Display Panel
1 display
2 display cable connector
3 computer base
4 pull-tab
5 connector
1 display bumpers (8)
4 display panel
2 M2.5 x 6-mm screws (8)
5 top cover
3 display bezel
6 M2 x 3-mm screws (9)
CAUTION:
Before performing the following procedures, read the safety instructions in your
System Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Carefully separate the bezel from the top cover to avoid damage to the bezel.
