Dell PowerEdge M420, Reference Manual

Page: 1384 / 1682

1380
Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to
set conditions for the management access list.
Syntax
deny [ gigabitethernet
unit/slot/port
| vlan
vlan-id
| port-channel
port-
channel-number
| tengigabitethernet
unit/slot/port
] [ service
service
] [ priority
priority
]
deny ip-source
ip-address
[ mask
mask
|
prefix-length
] [ gigabitethernet
unit/slot/port
| vlan
vlan-id
| port-channel
port-channel-number
|
tengigabitethernet unit/slot/port
] [
service service
] [
priority priority
]
• gigabitethernet
unit/slot/port
— A valid 1-gigabit Ethernet-routed port
number.
• vlan
vlan-id
— A valid VLAN number.
• port-channel
port-channel-number
— A valid routed port-channel
number.
• tengigabitethernet
unit/slot/port
— A valid 10-gigabit Ethernet-routed
port number.
•
ip-address
— Source IP address.
• mask
mask
— Specifies the network mask of the source IP address.
• mask
prefix-length
— Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
• service
service
— Indicates service type. Can be one of the following:
telnet , ssh , http , https , tftp , snmp , sntp , or any . The any keyword indicates
that the service match for the ACL is effectively "don’t care".
• priority
priority
— Priority for the rule. (Range: 1–64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
2CSPC4.XModular-SWUM200.book Page 1380 Thursday, March 10, 2011 11:18 AM